Open: 8:00AM - 5:00PM | Sat: 8:30AM - 12:30PM
Ready to Ship High Demand

Peugeot 308 Brake Calipers

Aftermarket brake calipers engineered to slot into the Peugeot 308. Cross-referenced against OEM specs and dispatched countrywide from our warehouse

Speak to a Specialist
Fitment-Verified Components
Dispatched in 24-48 Hours
Peugeot-Trained Team
Aftermarket Guarantee
Brake Calipers for Peugeot 308

What Are Peugeot 308 Brake Calipers?

Brake calipers clamp the pads onto the disc to slow your Peugeot down — fronts do most of the work on a 208 or 2008, rears add stopping bite on the 3008 and 5008. SA summer heat, coastal salt and infrequent brake-fluid changes are the three things that kill them here.

Signs You Need New Brake Calipers

Car pulls firmly to one side when braking
Sticky or dragging brake causing a burnt smell after driving
Uneven pad wear — inner pad thinner than outer
Juddering or pulsing through the pedal under braking
Brake fluid weeping from the piston seal or bleed nipple
Excess heat from one wheel after a short drive

Common Questions About Peugeot 308 Brake Calipers

How much does it cost to replace a Peugeot brake caliper?

Parts vary by model — 206/207 fronts are budget-friendly, while 3008 and 508 rears with electronic parking brakes cost significantly more. SA stockists include Sparesboyz and Modern Auto Parts for Ferodo units. Send your VIN for a free quote on the correct caliper.

What are the symptoms of a sticking brake caliper?

A pull to one side under braking, a burnt-pad smell, excess heat from one wheel and uneven pad wear are the telltales. Peugeot Forums has a long-running thread on rear caliper slide-pin seizure — this is the exact SA-climate failure we see weekly.

Can a Peugeot brake caliper be repaired or does it need replacing?

Many can be rebuilt with a seal kit and fresh piston if the bore is clean. Pitted pistons or corroded bores mean a full replacement. On 3008 and 508 with electronic parking brakes, we usually recommend a full replacement caliper — the motor and seals are not serviced separately.

Why does my Peugeot pull to one side when braking?

Most often a sticking caliper piston or seized slide pins — the bad side barely clamps and the good side pulls the car over. Contaminated brake fluid or a collapsed flexi hose cause the same symptom. Scan for ABS codes first to rule out sensor faults.

Where can I buy Peugeot brake calipers in South Africa?

We source new, used and reconditioned calipers nationally through SA stockists including Sparesboyz and AfricaBoyz. VIN-matching is essential because 208, 2008 and 3008 calipers differ by engine size and disc diameter. Send us your VIN for a same-day quote.

Not Sure Which Brake Calipers Fits Your 308?

Share your VIN or engine code and our Peugeot team will cross-check the correct brake calipers for your exact 308 variant.

Chat with Our Parts Desk
Chat with us!